Tech Support - I need help with BOMS and ISOS

[IveyMechanical]

First,
How do you make the length of pipe on the boms in the isos round off to an 1/8 or 1/16?


Second:
My iso manager keeps losing the iso names/drawings in the base drawing. This causes a problem when I go back and start creating the spool map for field use? Can you add these spools back to the original drawing?


Words of WisDOM:
"Given enough time and enough money, anything is possible"

[Chuck]

First - change your ddunits to either 1/8 or 1/16 as required.

[Chuck]

First - change your ddunits to either 1/8 or 1/16 as required.

[Chuck]

First - change your ddunits to either 1/8 or 1/16 as required.

Second - I've come across the same 'glitch'. But when a section of pipe has been labeled with the IsoMgr - it retains that bit of information. While creating your spool map, just check the pipe and there you go...