Kenneth
01-07-2003, 07:40 AM
I need some advice on the rolling offset with graded lines,
I use this quite often and there has to be a quicker way than how I do this. Need to use router line to find proper intersection and fittings to properly snap in with the odd roll.
I have attached a .dwg file to this thread for an example to complete. File will not go, can you guys adjust the file propertys so we can submit a .dwg ?
Thanks, Ken
I use this quite often and there has to be a quicker way than how I do this. Need to use router line to find proper intersection and fittings to properly snap in with the odd roll.
I have attached a .dwg file to this thread for an example to complete. File will not go, can you guys adjust the file propertys so we can submit a .dwg ?
Thanks, Ken