AutoCAD/DD3D crash when using "+" [Archive]

View Full Version : AutoCAD/DD3D crash when using "+"

OCD

10-11-2007, 08:20 PM

AutoCAD/DD3D crashes when escaping out of "+" (adding a joint of duct to existing joint of duct). Does any one else have this problem...is this on QuickPen's list of items to resolve?

Gman

10-15-2007, 07:51 AM

Hey OCD,
Are you using Design Center or is it opening when you start AutoCad? DD3D has an issue that if DC has been opened any acton that causes DD3D to open a dialog box crashes AutoCad. Closing DC does not stop this crash, if you have to open Design Center you need to save your drawing and restart AutoCad after you finish with DC.

OCD

10-15-2007, 10:43 PM

Yes, I had DC open. I have removed it from startup/drawing and the crash stopped...I get a DD3D error message, but no fatal error.
Thanks Gman.